Interval 6 Airtube
Lightweight and solid polyester flysheet fabric has high resistance to UV, does not age and retains its properties during prolonged exposure to sunlight and heat
It is a thin waterproof polyurethane layer applied several times on the inside of the tropic.Depending on the number of layers of coating, the tropic is resistant to water pressure up to 4000mm (Extreme and Hiking series), 3000mm (Trekking and Family series) and 2500mm (Outdoor series). The coating retains its elasticity even at very low temperatures well below freezing.
Interval 6 Airtube
A spacious inflatable tent with a variable arrangement of doors and a spacious vestibule has enough space for 6 people. Thanks to the use of Airtube technology, its construction is very easy and fast.
Rain fly is made of Polyester with a polyurethane coating, guaranteeing a water column of 4,000 mm. The seams are taped with waterproof tape.
The floor is made of Nylon with a Polyurethane coating, providing a 10,000mm water column.
Instead of tent poles, TPU inflatable tubes inserted into tunnels made of Polyethylene and Polyester fabric inside the Rain fly are used. The inflatable pump is included in the package.
|Weight without inner tent||17 kg|
|Package Size||76 x 46 x 35 cm|
|Number of people||5+|
|Amount of enterances||2|
|Amount of vents||4|
|Number of poles / crossing points||3 / 0|
|Buildable without a bedroom||Yes|
|Height of tent (bedroom)||210 (195) cm|
|Number of pins||44|
|Material of poles||Inflatable|
|Flysheet material||Polyester, PU coating 4 000mm H2O|
|Groundsheet material||Nylon, PU coating 10 000mm H2O|
Two-layer tent - consists of an inner and outer tent - rain fly. The inner tent has a rectangular floor plan with one entrance on its longer side. Rain fly has a spacious vestibule with two entrances (front and side).
It is based on the principle where the TPU inflatable tube is inserted into a tunnel made of Polyethylene and Polyester fabric inside the rain fly. Rain fly and the inner tent (which is suspended from the inside of the tropico) are erected at the same time after the tubes are inflated.
The advantage of this construction is the possibility to detach the bedroom from the tent, which stands alone and thus forms a single-walled tent with an integrated Polyethylene floor without a bedroom.
It is located in the upper corners of the vestibule (2 ventilation canopies) and one large ventilation window in the back of the tent. The ventilation hoods are designed so that they do not close on their own. In hot weather, it is recommended to also open the 2 front triangular mesh windows and the side mesh window to achieve the maximum ventilation effect.
Building a tent
Lay the rain fly on the ground and anchor it with pegs in the corners of the tent. Then open the screw cap on the third (lowest) tube, which is located at the back of the tent, insert the end of the hose into the valve and pump until you hear the whistle located on the pump hose. Then remove the hose and screw the hole. Do the same for the center and finally the front tube.
Inside the tent, hang the bedroom with plastic olives in rings on the rain fly. After hanging the inner tent, close all entrances and windows. Then tighten the tropic by pulling the straps at the corners of the rain fly. Subsequently, anchor all the loops of the tropic with pegs to the ground and turn off the tent with the anchoring cords.