The fiberglass rods are made with a new technology that achieves lower segment weight with increased resistance to breakage.
Lightweight and solid polyester flysheet fabric has high resistance to UV, does not age and retains its properties during prolonged exposure to sunlight and heat
It is a thin waterproof polyurethane layer applied several times on the inside of the tropic.Depending on the number of layers of coating, the tropic is resistant to water pressure up to 4000mm (Extreme and Hiking series), 3000mm (Trekking and Family series) and 2500mm (Outdoor series). The coating retains its elasticity even at very low temperatures well below freezing.
Single entrance, very easy to set up tent. Classic self-supporting structure with a large apse for storing luggage. Both the left and right triangular entrance can be used, or open both at the same time.
Rain fly is made of Polyester with a polyurethane coating, which gives it a water column with a height of 4,000 mm. Seams are taped with heating tape to prevent leaks.
The floor is made of layered Polyethylene with Rip-Stop treatment.
The tent poles consist of laminate segments with a diameter of 8.5 mm.
|⌀21 x 47 cm
|Number of people
|3 - 4
|Amount of enterances
|Amount of vents
|Number of poles / crossing points
|2 / 1
|Buildable without a bedroom
|Height of tent (bedroom)
|120 (115) cm
|Number of pins
|Material of poles
|Polyester, PU coating 4 000mm H2O
|Layered Polyethylene Rip-Stop
The tent is double-layered and consists of an inner tent and an outer layer – rain fly. The inner tent has a rectangular floor plan with an entrance on its longer side. The outer tent has a triangular apse on the side of the entrance, suitable for storing luggage, for example. We can decide whether to open the left or right half of the entrance, or both at the same time. We will use the option when cooking, for example, and thus create the necessary lee.
It is located at the top of the dome of the rain fly. The canopies of the ventilation windows are shaped so that they are not tilted by the wind, if necessary they can be closed with Velcro. This prevents leakage even during rain with strong wind.
Building a tent
Hang the inner tent with hooks on the structure made of crossed tent poles, the ends of which we insert into the metal hollow rivets in the corners of the floor. We pull the rain fly over the structure and insert the tent pole tensioning the vestibule into the perforated sleeve, insert it into the metal hollow rivets and tension it into the arch. Then we attach the Velcro fasteners on the underside of the rain fly to the tent poles. Fasten the plastic three-pronged clips on the lower edge of the rain fly and pull it tight. Anchor the tent with pegs and cords.